How to Read a Tire Size: Sidewall Codes, Load Index, Speed Rating and Date Code

6 min readUpdated November 17, 2026Reviewed by Faisal Mohammad, Licensed Automotive Service Technician

Where to find your tire size

You can read your size in two places. The first is the sidewall of the tires on your vehicle. The second, and more reliable, is the tire information label. Transport Canada says it is usually on the edge of the driver's door or the door post, and sometimes on the glove box or fuel door. Your owner's manual lists it too.

Why the label beats the sidewall: the tires on your vehicle may not be the original size if a previous owner changed them. The label shows what the vehicle maker specified. Check both axles, because some vehicles use different pressures, and some use different sizes, front and rear.

Shop-floor tip: take a photo of the label and of one sidewall before you shop. You can zoom in on the small print later instead of kneeling beside a dirty tire in a parking lot.

Decoding the size: P205/55R16

Transport Canada uses this example, and it is a good one to learn on:

  • P: passenger tire. LT means light truck. Some tires have no letter here.
  • 205: the width of the tire in millimetres.
  • 55: the aspect ratio, meaning the sidewall height is 55% of the width. A lower number means a shorter sidewall.
  • R: radial construction.
  • 16: the wheel diameter in inches.

Load index and speed rating: 89V

After the size comes the service description. In Transport Canada's example, 89 is the load index and V is the speed rating. The load index is a code for the maximum load each tire is built to carry when properly inflated. The speed rating is a letter for the tire's maximum speed capability. Neither is a recommendation to drive at that speed.

Transport Canada advises that new tires should have the same load capacity and speed rating as the original tires, and that tires of the same type, size, speed rating and load index go on all wheel positions.

Pay close attention to the load index on SUVs, pickups and anything you load heavily. It is easy to find a tire in the right size with a lower load index, and that tire is not a like-for-like replacement.

One more number trips people up: the maximum pressure moulded on the sidewall. Transport Canada notes it is the pressure needed to carry the tire's maximum load, not the recommended pressure for your vehicle. Inflate to the pressure on the tire information label, measured when the tires are cold. Transport Canada counts tires as cold if the vehicle has been parked for at least three hours or driven less than 2 km, and notes they lose about 1 psi (7 kPa) for every 5°C drop in temperature, so check monthly through the fall.

Know your size? Shop by it.

Shop new tires by size and season, with tax and eco fees shown before checkout. Not sure what you are reading? Send us the code from your sidewall.

The DOT code and how to tell a tire's age

Every new tire carries a tire identification number (TIN), often printed after the letters DOT. Under Canada's Motor Vehicle Tire Safety Regulations, it includes symbols for the manufacturer, two symbols for the size, and four digits for the date of manufacture: the first two are the week, the last two are the year.

So 1426 means the 14th week of 2026. NHTSA, the U.S. traffic safety agency, gives the example that 0308 means the third week of 2008. Look on both sides of the tire, because the full number may only appear on one sidewall.

Why it matters: NHTSA notes that tires age even when they are not driven much, and that some vehicle and tire manufacturers recommend replacing tires that are six to 10 years old regardless of tread. If you drive little, or you are looking at a spare or a seasonal set, check the date code as often as you check the tread.

Other sidewall markings worth knowing

A few more symbols tell you what the tire is built for and when it is worn out.

Season is part of reading a tire, too. Transport Canada notes that below 7°C, all-season and summer tires begin to lose elasticity, while winter tires keep their grip at much lower temperatures. That is why the mountain snowflake symbol is the marking to look for on a winter set.

  • Maple leaf: Canada's national tire safety mark. Transport Canada says it means the manufacturer certifies the tire meets Transport Canada requirements.
  • Peaked mountain with snowflake: the tire meets specific snow traction performance requirements and is designed for severe snow conditions.
  • M+S: mud and snow. It is a different marking from the mountain snowflake, so check for both if winter traction matters to you.
  • Treadwear, traction and temperature grades: a U.S. rating system moulded on passenger tires sold in the United States. NHTSA says a higher treadwear number means the tread should take longer to wear down.
  • Tread wear indicators: small raised bars in the grooves. Transport Canada says a tire must be replaced when the tread wears down to them, at 1.5 mm (2/32 of an inch).

Putting it to work: a quick example

Say your door label lists 215/60R16 95H. The steps below show how to shop with that code in hand.

If the codes on your current tires do not match your label, or you are moving winter tires onto a different wheel size, send us both through the quote form and we will reply by email with options that fit.

  • Filter by 215/60R16 in the season you need: all-season, winter, summer or all-weather.
  • Keep the load index at 95 and the speed rating at H, as on the original.
  • Put the same tire type on all four wheels.
  • Check the date code on delivery and keep your order paperwork.
  • Register the tires with the manufacturer, as Transport Canada recommends, so you can be reached if there is a recall.

Key takeaways

  • Use the tire information label on the driver's door or door frame as your reference size.
  • P205/55R16 reads as type, width in mm, aspect ratio, radial construction and wheel diameter in inches.
  • Match the original load index and speed rating; a lower load index is not a like-for-like swap.
  • The last four digits of the DOT code are the week and year of manufacture.
  • Inflate to the pressure on the label, not the maximum moulded on the sidewall.

Frequently asked questions

Can I use a different tire size than the original?

NHTSA advises buying tires that are the same size as the vehicle's original tires or another size recommended by the vehicle manufacturer. If your owner's manual does not list an alternative, stick with the size on the tire information label.

I cannot find the date code. Where is it?

Look on both sides of the tire. Canadian rules require the full tire identification number on at least one sidewall, so the four-digit date may be on the side facing the vehicle.

How old is too old for a tire?

NHTSA notes that some vehicle and tire manufacturers recommend replacing tires that are six to 10 years old, regardless of tread. Check your owner's manual and the tire maker's guidance, and replace sooner if you see cracks or bulges.

Do winter tires need the mountain snowflake symbol?

Look for it. Transport Canada says tires with the peaked mountain and snowflake symbol meet specific snow traction performance requirements and are designed for severe snow conditions.

Can you help me read my sidewall?

Yes. Send the full code from the sidewall, or your vehicle's year, make, model and trim, through the quote form. We reply by email.

Sources

FM

Technical review

Faisal Mohammad, Licensed Automotive Service Technician

Faisal Mohammad is a Licensed Automotive Service Technician and operations partner at Best Tire Shop Near Me. He has 22 years of experience in the automotive industry, with extensive experience in tires, wheels, automotive repairs and partner-installer operations across Ontario.